Variable-rate zones

Making zones from the survey, setting rates and loading the file onto a spreader or drill.

The Zones tab turns the crop health picture into zones you can load onto a variable-rate spreader or drill. The portal draws the zones; you decide the rate for each. It never suggests a rate.

Before you start

  • The tab is only there when the survey has crop health (the Vegetation button above the map).
  • The zones show where the crop differed on the day of the flight. Why it differed is for you and your agronomist to judge, ideally by walking the patches first. The field app will take you to them.
  • Fertiliser rates are your responsibility, with your adviser, under the rules that apply to your land. The portal is a mapping tool.

Making a plan

  1. Open the survey and choose the Zones tab.
  2. Give the plan a name, such as "Nitrogen 1".
  3. Choose the application (fertiliser, seed, lime, growth regulator, spray or other) and the unit your machine uses (kg/ha, l/ha, t/ha, seeds/m2 or plants/m2).
  4. Leave Zones from the index selected and choose how many zones, 2 to 6. Four is a good start.
  5. Smallest patch is the smallest area a zone may have, in square metres. Patches smaller than this are merged into their neighbour so the machine is not switching every few metres. 100 m2 suits most spreaders; make it larger for a wide boom.
  6. Choose Whole survey, or Draw a boundary to zone part of the field: left click the corners on the map, right click to remove the last corner, then press Finish.
  7. Press Generate zones. Within a second or two the field is coloured red (lowest index) through to green (highest), and a table lists each zone with its area and average index.
  8. Type a rate for each zone, and a note if you want one. Hover a zone on the map to see its rate.
  9. Press Save plan.

A reseeding map

Choose Reseeding map instead of zones from the index. Set the index value: everything at or below it becomes the Reseed zone and the rest is Leave. If nothing falls at or below the value the portal says so; raise it and try again.

Saved plans

  • Open shows a saved plan on the map with its rates. Change the rates and press Save rates.
  • Copy zones starts a new plan with the same zones, so a second application in the season can use the same boundaries with different rates.
  • Shapefile downloads the file for your machine.
  • Delete asks you to press it twice.

Each plan belongs to one survey. Fly the field again and you can make new zones from the new picture.

Loading the file onto your machine

The download is a zip holding a shapefile (the .shp, .shx, .dbf, .prj and .cpg files) and a short README. Almost every terminal and farm software package reads a shapefile. The polygons are in latitude and longitude (WGS 84), which is what terminals expect. Each zone carries these columns:

ColumnWhat it holds
ZoneThe zone number, 1 being the lowest index
RateThe rate you typed
UnitThe unit you chose
MeanIdxThe zone's average vegetation index
AreaHaThe zone's area in hectares
NoteYour note
  1. Unzip the download onto a USB stick, keeping all the files together in one folder.
  2. On the terminal, import or open the shapefile as a prescription or application map. Where the terminal asks which column holds the rate, choose Rate.
  3. Check the zones sit on the right field on the terminal's screen before you start.

Some terminals want their own format rather than a shapefile. Tell Tendrone which terminal you have and we will look at adding it.

On the field app

Saved plans travel with the survey to the Crop Health Navigator app. On the phone you can see the zones and rates, read which zone you are standing in, walk from zone to zone, and make notes that record the zone.