What each map layer shows
Ortho, Elevation, Bare earth, NDVI, Vegetation, Contours and the 3D model.
Each button above the map shows a different picture made from the same flight. Only the ones made for this survey appear.
| Button | What you are looking at | Good for |
|---|---|---|
| Ortho | The aerial photo, straightened so every point is in its true place, like a satellite picture but far sharper. | Seeing the field as it was on the day. Measuring distances and areas. |
| Elevation | The height of the surface, coloured from low to high. The surface includes the crop, hedges and buildings. | Where water will sit or run, the lie of the land, reading rises and falls. |
| Bare earth | The same, with the crop and buildings taken off so you see the ground itself. | Drainage and levels under a standing crop. |
| NDVI | A plant health picture from a multispectral camera, where one was flown. Green is healthy, red is poor. | Spotting differences in the crop. |
| Vegetation | Crop health worked out from the ordinary photo (the VARI index). Drawn over the picture showing. See the guide "Crop health colours". | Spotting differences in the crop; the basis for zones. |
| Contours | Lines of equal height drawn over the picture. See the guide "Contour lines". | Reading slopes at a glance. |
| 3D model | The field as a solid model you can turn, where one was made. | Buildings, heaps, banks and ditches. |
A health picture shows where the crop differs. It does not say why: nitrogen, water, compaction, disease and pests can all look alike from the air. Walk the spot before deciding.
Heights in this portal are always relative, never above sea level. Elevation colours run from the lowest ground in the survey to the highest; the height tool reads the rise or fall from a point you choose.