The height tool reads how much the ground rises or falls between two points. It is on the Map options tab and opens when you choose Elevation above the map. It is only there when the height readout was part of the survey.
Using it
- Choose Elevation above the map.
- Press Measure on the Map options tab.
- Left click your zero point: the place you want to measure from, such as a gateway or a drain outlet.
- Move the pointer: the rise or fall from the zero point reads under it as you go.
- Left click an end point to fix the reading. It shows the rise or fall, the distance and the gradient.
- Right click cancels. Press Measure again for a new zero point.
What the figures are
Every figure is a difference from your zero point: "1.6 m lower" or "0.8 m higher". The portal never shows a height above sea level, because a drone survey does not measure that reliably. Differences across a field are measured far better than any absolute height, which is why only differences are shown.
The heights are of the surface the drone saw. On a standing crop that is the top of the crop, not the soil. Choose Bare earth where it is offered to see the ground with the crop removed.